In this post Standard Operating Procedure of Operation of Vibro Sifter 30”in Pharmaceuticals is describe.
1.0 OBJECTIVE:
To lay down a procedure for Operation of Vibro sifter 30” (Bectochem).
2.0 SCOPE:
This SOP is applicable to the Operation of Vibro sifter 30” (Bectochem) in granulation area.
3.0 RESPONSIBILITY:
Production: Technical Associate/Officer /Executive/Assistant Manager. Head Production: To ensure
execution & compliance.
Head QA: To ensure the compliance.
4.0 PROCEDURE:
4.1 OPERATION:
4.1.1 Machine Setting
4.1.1.1 Ensure that the equipment is cleaned and ready for use.
4.1.1.2 Ensure that the main power supply is switched OFF.
4.1.1.3 Assemble the discharge chute with sifter body and then tight the holding clamp by
pressing towards sifter.
4.1.1.4 Place the required sieve as per BMR, place SS frame and feed hopper and then tight the
clamp by pressing towards sifter.
4.2.2 Operation
4.2.2.1 After line clearance from QA, put the “UNDER PROCESS” label on the machine.
4.2.2.2 Enter the start time of the batch in equipment sequential log as per SOP.
4.2.2.3 Use hand gloves and nose mask while sifting the materials.
4.2.2.4 Place the Material to be sifted adjacent to the sifter.
4.2.2.5 Keep the cleaned IPC below the discharge chute of sifter.
4.2.2.6 Switch “ON” the main supply.
4.2.2.7 Feed the material to be sifted manually one by one scoop above the sieve.
4.2.2.8 Collect the sifted material from the discharge chute in IPC, collect the oversize from
sifter sieve and mill the oversize using Multi mill as per BMR.
4.2.2.9 Enter the sifting completion time in equipment sequential log book as per SOP.
.webp)
%20Web%20of%20pharma%20.webp)
%20webofpharma.JPG)
