Vernier caliper Operational SOP




1.0  OBJECTIVE:
To lay down the operating procedure of digimatic vernier caliper.
2.0  SCOPE:
This shall be applicable to the digimatic vernier caliper of Quality Control Instrument Laboratory.
3.0  RESPONSIBILITY:
3.1  Technical Assistant/ Helper.
3.2  Q.C Analyst.
4.0  ACCOUNTABILITY:
4.1  Manager-Quality Control.
5.0  MATERIAL AND EQUIPMENT:
5.1  Digimatic vernier caliper.
5.2  Tablets.
6.0  PROCEDURE:
6.1  Ensure that the instrument is clean. Follow the SOP No. BM/QCEC/SOP047-00.
6.2  Switch ON the caliper by pressing ON/OFF button.
6.3  Press ZERO/ABS button.
6.4  Press In/mm button for desired output in inches/millimeters.
6.5  Check whether the display is 0.00mm/0.0000in as per the mode selected in.
6.6  Close the measuring jaws. Read display.
6.7  If display is not zero 0.00mm/0.0000in. Adjust it to 0.00mm/0.0000in.
6.8  Clean the jaws.
6.9  Close the jaws completely.
6.10    Press the ORIGIN button to get display zero.
6.11    Place clean sample in between measuring jaws and close the jaws.
6.12    Record the reading displayed.
6.13    Switch off the display by pressing ON/OFF button.
6.14    Take out the sample, clean the jaws and keep the caliper in case.
7.0  REVISION LOG:
Revision No.
Effective Date
Reason
00

New SOP

8.0  REFERENCES:
8.1  Not Applicable.
9.0  ANNEXURES:
9.1  Not Applicable.
10.0    ABBREVIATIONS:
Abbreviation
Expanded Form
SOP
Standard operating procedure
&
And
No.
Number  
Ltd.
Limited
Q.C
Quality control
QCEO
Quality control equipment operation
F
Format


No comments:

Post a Comment